Setting up a Wavestore to be an SNMP Agent
Note that we support SNMP v1 and v2c for both requests and traps. (We do not support the now obsolete SNMP v2, usually requests for v2 mean v2c but do check this!).
Wavestore SNMP is disabled by default for security, but can be enabled by the installer via a configuration option.
SNMP is installed by default, but not enabled. This may be set up in the System Monitoring section:
Community=WAVESTORE ReadOnly=10.1.0.0/16
Customise the values as needed. It is necessary to provide at least one parameter to activate SNMP.
It is recommended that the ReadWrite field is not set, as it allows a remote user to change critical system parameters.
Field are:
- Community - Default is "WAVESTORE". The community name is used to group devices together by organisation. It's perfectly fine to omit this parameter.
- SysLocation - Default is "Default Wavestore Location". This is a text field describing the device location. It's not mandatory but recommended to include this parameter.
- SysContactName - Default is "Default Wavestore SysContact". This is a text field for the contact name of the person responsible for device. It's not mandatory but recommended to include this parameter.
- SysContactEmail - Default is "Default Wavestore Email". This is a text field for the contact email of the person responsible for the device. It's not mandatory but recommended to include this parameter.
- ReadOnly - Default is "192.168.0.0/16" - This field defines the subnet from which read-only operations can be performed. The subnet is expressed in CIDR notation.
- ReadWrite - Default is "192.168.0.0/16" - This field defines the subnet from which read-write operations can be performed. The subnet is expressed in CIDR notation.