iDrac 9 Wavestore Preparation
Setting up MegaRAID on a new Dell server with iDrac9:
- Login to the iDrac of the server
- Navigate to Configuration> Storage Configuration> Physical Disk Configuration
- The SSD on that server is in a ‘Non-RAID’ state and needs to be converted into ‘RAID capable’ or ‘RAID mode’.
- Click Action and choose the ‘Convert to RAID mode’ option.
- Click ‘Apply’ on the bottom of the page to confirm the changes.
- Underneath Physical Disk Configuration you will find Virtual Disk Configuration. Expand that menu.
- Add the SSD as a virtual drive. (If it asks you to specify a size, enter the SSD size (e.g 223.57GB).
- Click ‘Apply Now’ on the bottom of the page to confirm the changes.
- Navigate to Configuration> Storage Configuration> Physical Disk Configuration.
- Change the controller to the PERC H730P Adapter.
- Set all physical drives (making sure there are no SSDs listed) to ‘Unassigned Hotspare’.
- Click ‘Apply Now’ on the bottom of the page to confirm the changes.
- Install Wavestore.
- Log in to Wavestore.
- Navigate to (View -> Setup -> Server -> Storage).
- Check if the disks are displayed. If not, it is most likely because MegaRAID is off.
- To check the status of MegaRAID, go to (Tools -> Execute Command) type in megaraid -v and click RUN
- If MegaRAID is off, type in megaraid on and click RUN
- Reboot the server and check the disks again
Once you’ve completed all the steps above, please provide us with Teamviewer QS access so we can confirm the configuration is correct on both iDrac and Wavestore’s side.