Camera not licensed

If more cameras are enabled than licensed, then some will fail to stream with an Unlicensed error. Licence channels will be allocated on a first-come-first-served basis and therefore the cameras which fail as unlicensed might change. Do not leave a system with some channels enabled but not licensed.

Either:

  • (a) Purchase another licence with the correct number of channels. Once this is applied, the system will restart and all camera channels will restart, or
  • (b) Disable the cameras which are not wanted so only the correct number of cameras are enabled. Note that this won't automatically restart any camera channels which failed to obtain a licence before; restart the server to restart these channels.

Note that if you've just added one new camera channel and that exceeds the maximum licensed, disabling the new channel should be sufficient and it would not normally be necessary to restart the server in this case.

EMS licences

Where Encoders or multi-sensor cameras are present, if there are inadequate EMS channels then normal IP channels will be used for the cameras or encoder channels. This might cause other cameras to fail as unlicensed. Follow the steps above.

Device database upgrades to fix unlicensed issues

If a Device Database upgrade has been supplied to fix an unlicensed issue, and it still shows licence errors after the upgrade, this is because you did not disable the cameras before doing the upgrade, and they loaded the cached details and failed as unlicensed before the new device database details were checked. Perform a server restart (after a couple of minutes), and the cameras will restart using the new device database details.

Missing items from Device Database

If it's not working because we are missing an EMS entry or similar from the device database, we need to execute command "camera N" for the appropriate N:

Command:   camera 23

The result should show the manufacturer and model strings, and also say which Device Database entry was chosen. Contact technical support to update the device database, which we can often do in a matter of minutes. We need the exact strings.

This information is also in the camera log, but the camera log gives lots of verbose output.

Example of camera command:

Command: camera 23

ONVIF camera
Manufacturer: Bosch
Model: FLEXIDOME IP starlight 8000i
Firmware: 7.10.0074
Serial Number: 044516591825041010
Device Database Entry: BOSCH