SSD: System drive unknown, wear will not be monitored

The Wavestore server has a system to monitor the life of an SSD when the operating system is installed to one. This is so that the software can issue a warning when the life of the SSD is coming to an end, which can obviously result in a system failure.

To be able to monitor and report this, it is necessary to use a supported SSD model because the "wear level" statistics are handled differently on different devices.

The error message "SSD: System drive unknown, wear will not be monitored" is stating that you are using an unsupported SSD and so the Wavestore will not be able to monitor the life of the device. You can disable this message by adding an appropriate section into the configuration using the WaveView "Setup | Advanced Configuration" screen, as follows:

  [SmartSSD]
  Enable=n


This will stop any fault messages about the SSD not being monitored.

Currently, we support Intel, Toshiba and some Kingston SSDs, but more will be added over time.

Note that prior to version 6.2, there was a bug which caused this message to be erroneously reported. If this is experienced, upgrade to the full version 6.2 release, delete the [SmartSSD] section, and it will be recreated automatically upon reboot without the problem.