Running Wavestore on Virtual Machines

  • Keywords: Virtual machines, Virtualization, Virtualisation, VMs, VMWare.

We can run Wavestore software on real hardware, or on a virtual machine in V6.  Currently we only recommend VMWare for a Virtual Machine system.

We have tested Virtual Box which is sufficient for a demonstration of Wavestore but lacks facilities which allow it to be used for a reliable server machine.

Licensing issues

Use of VMs provides an issue with licensing, so we licence such machines using a USB Hardware Dongle or Network Machine ID in V6.  Please use V6.34 or later for this, as the system used for network Machine ID has been improved in 6.34 and the old system withdrawn.

Migration of VMs between hardware

If a user desires to migrate the VM to another hardware platform, then Network Licensing (Network Machine ID) might be more appropriate: the Network Machine ID will follow the VM as it migrates and the licence will be retained (providing the details of the machine remain unchanged). However such VM systems are unlikely to be ideal for an I/O intensive application like the Wavestore, and downtime will be seen during migration.

Wavestore Failover solutions are recommended if a redundant system is required.  This is far preferable to VMs.

The use of VMs complicates calculations on bandwidth and throughput, but this should be left to the VM vendor, we should not get involved. If a customer asks for our recommendation, we have our own Failover solution which doesn't migrate the entire machine but just the configuration file, and is therefore might be faster to switch over when a failure is detected.

VMWare Setup

  • Bits: 64
  • Memory: 2GB or more (4GB recommended)

VMWare versions supported:

  • ESXi 6.5
  • ESXi 7.0
  • ESXi 8.0

Installation parameters:

  • OS "Other Linux 3.x 64 bit"
  • Memory: 4096MB
  • Network: bridged
  • Hard Disk: 32GB
  • Install DVD = the ISO file to install
  • Name it "Wavestore V6" or similar

Client Resolution Issues

Very often when running in a VM, the user interface defaults to a resolution of 800x600. This is lower than the minimum required by WaveView. It can cause an annoying issue where it's not possible to click the menus at the top of the user interface.

To resolve this, switch to a resolution of 1024x768 or higher. This can be done as follows:

  • Move the mouse to the top-left of the screen - a panel should drop down.
  • Within the icons shown in the panel, one is called "Displays". Click that one.
  • Choose the appropriate resolution and click Apply, then follow the instructions.