Configuring Boost record mode (V6.14)
Assuming that the cameras installed on site allow configuration of ONVIF stream profiles from the Wavestore server (and also allow dual streaming of ONVIF Stream Profiles, with one of the camera's streams configured as MJPEG), you can setup boost record mode (to be triggered by Motion events detected by the Wavestore server itself) as follows:
- Login to the server as an install level user
- Follow View > Setup > Cameras > Cameras Tab
- Select the first camera that you wish to configure for this mode of operation
- In Mask Options menu, adjust the Motion Mask and sensitivity for that camera as required
- Repeat for any other cameras required
- In the Camera groups menu, configure the camera group that the camera is allocated to as capture type 'ONVIF', enable 'Smart Search/VMD' & 'Allow Wavestore to configure camera streams', and disable 'Pullpoint'
- In Stream 1 settings, configure the camera stream values as you require (e.g. resolution/data rate/capture rate/GOP size)
- In Track 1, confirm that Stream 1 is selected
- For the Recording Rate, divide the capture rate value by the GOP size (the values that you set earlier), and round up to the next whole number, then enter this value (e.g. capture rate of 15/GOP size of 15 = 1)
- Set Boost Rate as 'Same as Capture Rate'
- Set Recording Mode as Normal, and click the I> icon on that line to expand the branches of the tree
- Configure Schedule as required (e.g. 'Always On' for this mode of recording to operate 24/7) and set the Pre Boost value as required (e.g. 5 seconds)
- Click Save
In the Event Rule menu, configure as follows:
- Cause: Motion on Camera N
- Action: Boost Track 1 - Camera N - Event Type 'On' - Post Event Time (e.g. 5 sec)
- Click Save