Auto-Formatting

Auto-Formatting provides the following:

  • Wavestore servers auto-detect changed drives if autoformat is set. This is useful for swapping drives within an array as well as for single drive volumes. Effectively the server automatically does the same as clicking on Add-Swapped-Drives in this case.
  • Wavestore servers auto-format single drive volumes if autoformat is set and the disk is blank (even if the single drive volume is marked Failed).
  • To enable auto-format all you need to do is enable the checkbox in the storage screen for the drive/array you'd like to use it on.

Following Scenarios will allow Auto-Formatting:

  • Single drive volumes will be automatically formatted if they are new and blank. Note we do not auto-format any single drive volumes which are not blank.
  • Single drive volumes which are already formatted as single drive volumes will be imported and it will continue to record without being reformatted.
  • Disk arrays will still need manual format when they are new or not formatted.
    • One exception is a new array which consists of all new blank drives. This will usually Auto-Format the array upon creation, however it is recommended you do not rely on this behaviour and manually format any new array.
  • A replacement disk in a working Disk Array is automatically formatted and rebuilt when it is changed without the need for the user to click anything.

The Wavestore server adds extra checks once it autodetects a changed drive to ensure it is actually working. These checks might take some seconds; they deliberately take a while so we ensure the drive is properly plugged in and isn't about to go away again. It is also important to be certain it is not actually formatted, and it is blank and working, before a format is performed.